How To Remove Water Filter From Kenmore Coldspot Refrigerator

Are you questioning how to replace water filter in kenmore coldspot refrigerator? Have you changed your water filter after six months to use your fridge?.

Once you purchase your new filter which volition install and supercede information technology with an onetime ane whenever you open up the package you're going to get the new filter a sticker to proceed the inside of your fridge to tell you when to change the filter and the filtered datasheet.

there are a few different types of these filters and they all have a six-month or a certain gallon that they're really skilful for some fridges actually have an indicator organisation that the light comes on and tells you when to modify the filter before nosotros take the filter out.

In this article we'll prove you how to replace h2o filter in kenmore coldspot refrigerator moreover we'll show you lot how to change Kenmore aristocracy refrigerator water filter, how to replace Kenmore refrigerator water filter 9690.

How to replace water filter in Kenmore coldspot refrigerator

But earlier nosotros start you lot may know:

Where is the water filter on a kenmore coldspot fridge?

Most water filters are positioned inside the grille on the backside of the fridge or the back, upper-right corner of the fridge.

Some models, ofttimes older ones, have the filter on the exterior at the back of the fridge on the water supply line.

Where is the water filter on elite fridge?

Nearly water filters on the elite fridge are located inside the fridge on the top dorsum of the refrigerator, the upper-left corner of the inside refrigerator.

before start:

proceed in mind anytime you work on a piece of equipment make certain it is unplugged or the circuit breakers are off so there's no take a chance of electrocution.

How to supercede h2o filter in kenmore coldspot refrigerator

you may desire a little hand towel downward on the floor to catch whatsoever water that comes out in social club to take the old filter out of the fridge.

you'll need a 1-gallon pitcher as you will have to swap out four gallons of water in one case you supersede the filter to flush the organization one time you lot have installed the new filter

Step1. Take out the older water filter.

Get down to the lesser of the fridge and detect your filter on the right corner on the grill fridge.

In one case you find your h2o heater you notice that there is a button next to the filter

push on that button release and then your tap on the height of your filter.
Push the push button in.
pull the h2o filter straight out the pull the filter out.

Once y'all pull out the filter.

Step2. Install the new water filter.

have the new filter out of the package on the top of your filter you lot're going have a protective dust cap remove that .
Take your new water filter and slide inside the plastic cap that y'all removed from the previous filter until you line up the marks.

in order to put the new filter in all you take to practice is:

line it up with the filter housing
push it in till you feel it seat, information technology will lock information technology into place

in one case you end the installation of the new water filter.

Step3. Flush out the fridge.

affluent out the 4 gallons of new water

go your i gallon pitcher and put within the dispenser.

burn your 4 gallons of water one affair you lot prefer to try to practise is reuse that water if you lot have some plants inside a garden outside anywhere you can use some water outside of drinking it as y'all desire to wait till yous've burned the iv gallons of h2o and cycled out the system with the new filter.

you lot can also simply have it to downpour downwardly the sink there make sure you lot become 4 gallons out your organization has

been flushed and you lot're ready to apply your new filter.

How to change kenmore elite refrigerator h2o filter?

most of the water filter replacements are going to be upwards on the top of the fridge.

the water filter is but a affair of pushing. If this sticker is missing, there's actually a little push button button right You button that in.

step1. Remove the quondam cartridge (one-time filter)

push inside the push both sides of the water filter cover and it simply snaps out of identify. And then you have the h2o filter.

Annotation: replacing the filter causes a small corporeality of water (around oz, or 25 cc) to bleed.

Identify a cup under the filter hole to catch any waste.
Pull the cartridge (erstwhile water filter) down.
Pull out the filter cartridge (h2o filter).

Note: when opened at the full bending the cartridge should easily come up out

Step2. Install the new cartridge ( new water filter)

Take the new cartridge (new water filter) out of its packing.

remove the protective cover from the 0-rings.
With cartridge ears within the horizontal position.
Push the new filter cartridge into the manifold hole until it stops.
Firmly lock in cartridge the cover will click on back into place.

Note: after changing the filter.

Step3. Flush 2.5 gallons through filter

Before apply ( flush for approximately 5 minutes)

Check the filter for leaks.

Step4. Reset the h2o filter

When the water filter indicator displays the bulletin O Filter calendar month

Hold three secends

Reset the water status display and indicator lite past pressing and holding the light/water filter push button for at least 3 seconds.

Annotation: filter Featherbed plug

Keep the filter bypass.

You lot must use the filter featherbed plug when a replacement filter is not bachelor.

Ice maker will non operate without the filter or filter featherbed plug inserted within the correct compartment.

How to supplant kenmore refrigerator water filter 9690?

Step1. Before installing your new filter, soak it in h2o for 15 minutes.

Step2. Press the button to open up the filter cover.

Step3. Pull the sometime filter downwards, and then remove it.

Annotation: If y'all have a Kenmore fridge, check if there is a plastic or metallic cap that covers the top of the old filter. If at that place is, pull off the cap and connect information technology to your new filter. If there is not, continue to step 4.

Step4. Push button the new filter into the compartment horizontally till information technology stops.

Step5. Push up firmly then far every bit it volition get.

Step6. Close the filter cover until it clicks into identify.

Step7. Run ii-three gallons of water through your fridge to remove air and lose carbon pieces.

Read besides:

How to remove Samsung refrigerator doors?
How to clean condenser coils on ge profile refrigerator?
How to conform temperature on LG refrigerators?
How to catechumen a fridge into a freezer?

BEFORE USING YOUR FILTER

If your fridge has a change filter indicator, reset it. To reset it: Press and hold the reset button for three seconds.

My Name is Elhoucine I am a passionate blogger, I have been searching and reading about the newly released gadgets, appliances, and products, and through this blog, I am trying to share some of the acquired experience to help y'all with everything related to home.

Source: https://homeoutmind.com/how-to-replace-water-filter-in-kenmore-coldspot-refrigerator/